There are mainly two ways for how to charge a motorcycle battery without a charger: attempt to jumpstart the battery and push start button.

How to charge a motorcycle battery without a charger

Always verify for the essentials, such as the following, before attempting the following solutions:

1. Make sure your tank is full with gas.
2. Check to see if the kill switch is turned off.
3. Check to see whether the spark plugs are loose.
4. Attempt to start your motorcycle while in neutral to get around some motorcycles’ built-in safety mechanism that prevents the rider from mistakenly starting a motorcycle while in gear.
5. Make sure the kickstand is in place. Some motorcycles have a safety mechanism that prevents them from starting if the kickstand is not up.

Jump Start The Battery

You’ll need to find someone willing to lend you their vehicle for a few minutes while your battery charges if you use this method. The methods for jumpstarting your batteries using a car, motorcycle, or portable jump starter pack are listed below.

1. The car’s engine should be turned off.
2. Connect the red clip to the motorcycle’s battery’s positive terminal.
3. The other red clip should be connected to the positive terminal of the car’s battery.
4. Begin riding the motorcycle.
5. Disconnect the jumper cables in the opposite sequence that they were connected.

How to Use a Portable Jump Starter Pack to Jump Start Your Motorcycle Battery

Motorcycle owners should have a portable jump starter on hand. This is the most efficient and secure method of recharging a dead battery.

1. Make sure the motorbike battery is turned off, as well as the portable jump starter.
2. Connect the positive red clip to the positive terminal with the positive red clip.
3. Connect the negative black clip to the negative terminal or a metal surface on the motorcycle. If the battery terminals are difficult to reach, use the chassis terminals instead.
4. On the portable jump starter, press the power button. Ensure that the portable jump starter is set to the voltage that your battery requires.
5. Make a valiant effort to start your motorcycle. Make sure you’re only cranking for 2 to 3 seconds at a time.
6. Remove the black clamp first, then the red clamp after the motorcycle has started.
7. Continue cycling and look for a mechanic nearby.

How to Use Another Motorcycle To Jump Start Your Motorcycle Battery

1. Make sure both motorcycles are turned off and in neutral.
2. Look for the connectors on the battery.
3. Once the positive terminal of the dead battery will be found then plugged in a positive clip to it.
4. Connect the positive terminal with the second positive clip.
5. Connect the negative clip to the deceased motorcycle’s metal surface.
6. Make an attempt to begin. Allow it to run for a few minutes if it has already started to confirm that your battery is functional.
7. Disconnect the connections in the opposite order that they were attached.

Activating The Start Button With A Push

Typically, this option is referred to as Push Starting. The act of engaging the transmission and pushing the car forward to start the vehicle’s machine is known as push starting.

How to Start a Motorcycle by Pushing It

1. Make sure you find a road that is clear and large enough for you to safely travel. Always keep an eye out for approaching vehicles to avoid any mishaps. If necessary, wear safety equipment like helmets and knee pads.

2. Set the motorcycle’s gear to first or second. Because first gear can force the motorcycle to accelerate forward and throw you off quickly, second gear is the most effective gear for this exercise.

3. Start pushing forward while holding the clutch. Aim at a speed of five to ten miles per hour. You have the ability to move forward –

• Waddling is the simplest option if your bike is light and you have long legs. Take your motorcycle out for a spin and begin pushing with your feet.

• Pushing alongside your bike — Once you’ve reached a comfortable speed, you should be able to hop on your bike.

• Pushing with the assistance of another person — simple for you, but requires some work on the other person’s part.

• Look for a route with a downward incline – You do not need to exert any effort; simply ride and let gravity assist you in gaining momentum.

4. Let off of the clutch and press the Starter Button when you’ve gained enough speed.

5. Apply a reasonable amount of throttle to the motorcycle.

6. If the motorcycle begins, you must re-engage the clutch to regain control.

7. Rev the engine with the clutch compressed to prevent it from dying down again.

8. Continue riding and seek out the nearest mechanic to have your motorcycle fully inspected.

Frequently asked questions for how to charge a motorcycle battery without a charger

Can I use a car charger to charge my motorcycle battery?

It needs to be charged! If you’re not careful, large automotive-type battery chargers, which are designed to charge a large vehicle or truck battery, can easily overload a small motorbike battery. Unfortunately, that may be the only sort of charger available in some situations.

What is the best way to charge a motorcycle battery at home?

For most battery types, use a trickle, float, or smart charger.

• Trickle chargers, often known as fully manual chargers, are the simplest to use. The AC electricity is converted to DC using these chargers.
• Another typical form of charger is the float charger.
• Smart chargers keep track of how much power is being drawn from the battery.

Is it possible to recharge a completely dead motorcycle battery?

If your battery is dead, you can either use a battery charger (which is recommended) or jumpstart your bike using another bike or a car. Once you’ve gotten the bike up and running, make sure you ride it for a while to re-charge it.

How long does a 12v motorcycle battery take to charge?

A motorcycle battery will take anywhere from 4 to 24 hours to charge. You should check the voltage every now and then to determine if the operation is complete.

How long does it take to charge a dead motorcycle battery?

Conclusion. It should take 2-3 hours to recharge your motorcycle battery, but it could take up to 24 hours. Make sure you don’t overcharge it by using a smart charger.

Is it possible to ride a motorcycle with a dead battery?

Is it possible to ride a motorcycle with a dead battery? In most cases, the answer is yes. You can still ride your motorcycle as long as your battery is capable of starting it.

How can I determine if the battery on my motorcycle is dead?

7 Symptoms of a Defective Motorcycle Battery

• Old Age.
• Idleness.
• Irregular Readings on the Multimeter.
• Receding Horn Volume and Dimming Headlights.
• Motorcycle Not Starting Properly.
• Built-Up Sulfation.
• A Deformed Battery.

Is it possible to charge a dead motorcycle battery with a trickle charger?

Some smart chargers may even de-sulfate your battery, bringing it back to life. A conventional trickle charger will just fire out a set number of amps and keep doing so, even if the battery is being fried.

Using a Trickle-Charger to Charge the Motorcycle

Check to see if your trickle charger is plugged into the wall. Connect the red clamp to the dead battery’s positive post. Reattach the cords and attempt charging again if the engine won’t start. You’re done if it does!

How many amps should a motorcycle battery be charged at?

The battery charger should not exceed 3 amps when charging a motorcycle or other compact battery. Because of the greater current output, most vehicle battery chargers are not acceptable. While keeping a battery at full charge will assure the longest possible life, overcharging can drastically shorten it.

When it’s time to charge a motorcycle battery for the first time, what should you do?

For the first time, I charged the battery.

• Recognize that the first time you charge the battery, you must do so correctly.
• Divide the Ah of the battery by 10 to get the charging amps.
• Using the crocodile clamps, secure your battery tender to the battery.
• While charging, keep an eye on your battery.

How long does it take to charge a dead motorcycle battery with a trickle charger?

How long does it take to charge a motorcycle battery with a trickle charger? – A time frame of 12 to 20 hours should be considered. Figures that are more accurate based on the kind and quality of the battery and charger.

What are the symptoms of faulty batteries?

5 Scary Signs That Your Car Battery Is Dying

• Backfiring.
• Needing to press on the gas pedal to start.
• Slow crank.
• Clicking sound when you turn the key.
• Dim headlight.

How long does a motorcycle battery last before it needs to be recharged?

How long will my motorcycle battery last if I don’t use it? A motorbike battery will typically die in 3-4 months if the motorcycle is not turned on. Turning your engine over is a very common approach for most riders to maintain their battery completely charged.